Dynaview III Specifications
| Maximum Web Speed | Special factory order for faster web: 2000 ft/min (600 m/min) standard. |
| Minimum Repeat Length | Standard 3″ (7.6cm) at 2000 ft/min (600m/min) or contact factory. Smaller repeat at lower speeds. |
| Resolution | 0.005″ (0.127mm) divided by the averaging factor, i.e., if averaging 10 repeats, resolution is 0.0005″ or 0.0127mm. |
| Chart and Meter Span | Set in recipe. |
| Screen Update Rate | 1, 2, 5, or 10 times per second set in recipe. |
| Control Output | 4-20mA output. Output is proportional to deviation from target length. |
| Control Output Gain | Set in recipe. |
| Binary Inputs (2) | Acknowledge and silence alarm; roll change signal. |
| Binary Outputs (2) | Warning and limit alarms. |
| Wheel Calibration Factor | Set in recipe. |
| Units | Uses a variety of units in both Imperial and Metric systems (cm, mm, ft, in, and more) |
| Recipes | More than 9,000 in a two-level selection structure. |
| Enclosure | Steel enclosure approximately 300mmx150mmx120mm (WxHxD). |